Sales & Support
Request A Quote - Email
Payment & Shipping Terms:
hydro power equipment,
industrial hydraulic equipment
In the early stage of the factory workshop, the design and installation of the ventilation system were generally not paid attention to when the plant was designed. Therefore, the roof of some enterprise workshops with large humidity will be seriously condensed, which will not only affect the equipment and products, but also increase the roof. Corrosion of steel structure (the occurrence of roof steel beam falling in a large domestic papermaking enterprise). The reason for the analysis is mainly because the outdoor cold air enters the room and combines with the high-temperature air, causing the indoor high-humidity air to condense into water droplets on the roof. The long-term water vapor and water droplets will cause corrosion of the roof steel structure and indoor equipment, and the life of the equipment and The safety of employees poses a certain threat.
Therefore, some enterprises added canvas curtains or shields to the hoisting opening in the later stage. However, the lifting port is the only passage for the entire workshop material and equipment to enter and exit the second floor, so frequent covering and lifting the door panel work is very cumbersome and inconvenient, which seriously affects the lifting work of the workshop, and the long-term frontal operation has certain dangers.
In response to the above situation, Oepoch designed a fully automatic hydraulic door for the lifting port. As long as an operator can easily open and close the door on the second floor. The design is currently used mainly in UPM and Lee & Man Paper Group, and the effect is very good. It not only facilitates lifting work, but also effectively solves the problem of closed space in the workshop. In addition, after installing the hydraulic door, the entire second floor workshop is spacious and tidy, and spare parts such as small weight can be temporarily stored on the cover.
The OEPOCH hydraulic floor hatch cover is suitable for all factory floor hoisting and can be customized according to the size of the customer's floor opening.
Features and advantages
1. It can isolate the workshop or pit space and isolate the flue gas and water vapor;
2, one-button opening and closing is convenient for the lifting operation of the lifting mouth;
3, comes with railings and handrails to ensure safe operation at the front;
4. After the door is closed, the floor space is saved and the overall aesthetics is improved.
5, personnel can walk on it, and according to customer requirements can be designed to have a certain carrying capacity, can meet the spare parts and bear the vehicle.
The opening and closing of the flap is controlled by a button of the control box. The flap opening is performed by manual operation. There will be a beep of about 5 seconds before the flap opening and closing action. When the flap opens, there are connecting rod protection device on the two sides of the openning flap.
The performance of coveing flap is carried out by the hydraulic cylinder.
The hydraulic cylinder power is hydraulic station.
|1||Power supply||380v 50/60Hz|
|5||Load||2KN/㎡ / Customized|
|6||Maximum uniform load||100 kN / Customized|
|7||Axial load||30KN / Customized|
|8||Control voltage||220v / Customized|